In order to create the mouth area, I needed to do something slightly different. I found a chrome pipe area on one of our chrome source pictures. I decided to use this segment for the mouth, as it was a nice long piece of chrome that I could transform into the shape of the mouth. I copied and pasted this segment onto our frog and Free Transformed it roughly in place until I was happy enough with the positioning of it. I also added this segment onto the head of our figure to create a median point on the figure.Next, all I had to do was fine tune and clean up the pieces to sit right on our figure. I did this simply by using the Smudge Tool set at 70-80% in strength, and about 7-10 pixels wide. Then I proceeded to smudge and smooth out the surfaces of the chrome pipe and mold them to fit the curves and contours of the frog's original mouth.